How to stick the concrete floor leather? Easy to do in 4 steps.

Now many people's homes are still cement floor, in order to make the ground more beautiful, they will choose to use the floor leather this material. Compared with wood flooring, it has a clear natural texture of wood flooring, and its price is more affordable, it can be said that floor leather is a substitute for wood flooring. Floor leather is not only beautiful, but also has the characteristics of sound insulation, moisture resistance, wear resistance and corrosion resistance. How to stick the concrete floor leather?

1. Before laying, we need to use a professional measuring ruler to measure the size of the room floor and make relevant records, and then cut the floor leather according to the measured size. It should be noted that the width of the cutting of the floor leather should be slightly greater than the required width, in order to facilitate the overlap and trimming when laying. For the cut floor leather should be placed at a room temperature of not less than 15 ° C for about 24 hours, so that the curled part of the floor leather can be fully extended to prepare for the placement.

2. Before laying, we need to clean up the ground, remove garbage and other debris, and clean up if there is oil or dust. Only after the ground is flat, clean and dry, can you apply glue. When laying, we should use a special binder to ensure that it has enough viscosity. When laying, we should ensure its flatness, for the convex place we should shovel and grind flat, the concave place can be 107 glue and cement to 1:2 weight ratio into paste, with a spatula to flatten, dry and then sandpaper.

3. Secondly, we need to use a special scraper to evenly spread the glue on the ground. At this time, we can not paint all the glue at once, the correct approach should be to paint a piece of paving a piece, in this order. When pasting should pay attention to align the edge line, when using a long handle brush to push out the pressure. And in the seam of the floor leather, a width of 10 cm should be left without glue to facilitate the treatment of the seam.

4. Finally, we need to use a special ruler to align it with the overlap, and then cut along the excess part with a knife, remove the cut edge, brush the appropriate amount of glue on the joint with a paint brush, and then close the joint with a press roller. The residual glue extruded at the joint should be wiped clean so as not to affect the beauty of the ground. At the same time, we should also check whether there are bubbles on the good floor leather and whether it is smooth. If there are bubbles, you can insert a syringe to suck out the air, and then compact.